December 8, 2013

12 Days of Christmas Treat Holders-Day 8!

Hi Stampers! How would you like to see a brand new treat holder today for my "12 Days of Christmas Treat Holders Day 8"! This is another quick & simple treat holder that can be mass-produced during our busy holiday season. Let's get busy:
 
 
We only need a few items for this adorable treat holder:


I used the "Square Framelits" for this one. I cut 3 pieces of designer paper & cardstock. For the designer paper I used the "Winter Frost Designer Paper" and cut (1) with the largest framelit which is scallop shaped on the edges. My 2nd square is "Island Indigo Cardstock" and my 3rd square is from the same designer paper but I picked a different pattern. Layer and glue all 3 pieces together.

Using a hand-held punch, punch a hole at two opposite corners. Fill your treat holder and curl the two corners upwards as shown below and tie a ribbon into a bow through the two holes. I used "Seam Binding Ribbon":


I stamped one snowflake using "Island Indigo Ink" and the "Festive Flurry Stamp Set" and cut out the snowflake shape using the coordinating "Festive Flurry Framelits Dies". I added a banner to the front of the snowflake that was stamped with the "Teeny Tiny Wishes Stamp" set and cut out with the "Bitty Banners Framelits Dies". I then punched a small hole at the top of the snowflake and threaded "Island Indigo Baker's Twine" through the hole and around the bow and knotted it in place:

 
Thanks for stopping by to visit!
 
 


debbiesdesigns2009@gmail.com

No comments:

Post a Comment

Thanks so much for visiting me today. I appreciate your comments!